If you’re having trouble with your Wavlink N300 extender connection, you’ve come to the correct spot. We’ve included a list of potential solutions to your Wavlink N300 Extender connection problems below. Okay, so let’s begin.
An inability to establish a connection with the extender is a typical problem encountered during Wavlink N300 setup and configuration. Users may get so frustrated that they give up on the setup procedure altogether if they encounter this issue. You should take a deep breath and read our whole write-up if you’re having the same problem. In this article, you will learn some exclusive tips and strategies for solving this problem for good.
Fixed: Can’t Connect to Wavlink N300 Extender
- Where exactly did you install your extender?
The location of the extender, router and PC or laptop being used for Wavlink setup is likely to blame for the connection problem. Position the three gadgets at a spot free of walls, indoor plants, or any other potential interference. When we talk about barriers, we’re referring to things like walls, floors, mirrors, glasses, cordless phones, microwaves, electric irons, refrigerators, radios, and so on. Also, keep in mind that any dust or debris around the router or extender might compromise its performance.
After you’ve finished installing, you may attempt to establish a link using Wavlink N300 Extender. If the problem stems from how you have your extender set up, this should fix it. If the opposite happens, go on to the next option to know another troubleshooting trick.
- Is the Firmware of Your Wavlink N300 Updated?
Firmware is a collection of programs that let your Extender Wavlink N300 or wireless router run efficiently at home or in the business. Therefore, the extender’s firmware should always be up to date. The wifi.wavlink.com website for Wavlink N300 extenders is where you can verify the current firmware version. If it’s the most recent version, setting up the extender shouldn’t be too difficult.
If that isn’t the case for you, locate your device’s model number. Launch your web browser and go to the Wavlink repeater setup page of your N300 range extender. Discover whether the most recent firmware update is available. If it’s there, get it as soon as possible.
- Are You Using Standard Security Protocol?
A WEP, WPA, or WPA2 Personal passkey is needed to join a protected wireless network. This occurs after altering the Wavlink N300 extender’s WiFi configuration. Verify the wireless extender’s settings to see whether you are inputting the correct password. Access the wireless extender configuration page by browsing its IP address in a web browser and clicking the wireless tab. There you may change the password and access all of your device’s settings. If you tend to forget things like this, write down your password now.
If you’re sure you’ve forgotten the previous password, you may either restore the extender to factory settings. To do so, open up your preferred web browser and go to the online configuration page. To have your password reset, click the corresponding link. Enter the previous password twice, and then type in the new one twice. Just hit the “Save Changes” button when you’re finished.
- Does Your Router Have Mac Filter Enabled?
The router’s innovative Wireless MAC (Media Access Control) Filter function is a standout among similar products. With this feature, you may control how many gadgets can join your network. Choose whether to block or allow certain MAC addresses. You should thus make use of the router’s or access point’s wireless MAC filtering functionality. Now, check if you can connect to your Wavlink N300 range extender.
That’s all you can do to do away with the “can’t connect to Wavlink N300 extender” issue. We are expecting that the tips mentioned above will fix the problem. However, if you choose to set up the extender again after resetting it, you have to access the http //ap setup or wifi.wavlink.com web address.