Wall Washer Lights are an attractive alternative to normal headlights when you’re driving at night. They were first introduced in the early 2000s, and since then they have become a popular choice among motorists. This is due in part to their bright, clean-looking light and their energy efficiency, which can save you money over time compared to halogen or incandescent bulbs. However, if your current Wall Washer Lights aren’t as effective as they once were, it might be time to upgrade them with new bulbs or ballasts – or even replace the entire unit!
The Benefits Of Switching To LED
If you’re on the hunt for a new Wall Washer Light, here are some things to consider. LEDs have much longer lives than other types of lighting. They last as long as 50,000 hours and produce about 85% less heat, which saves money on your energy bill and reduces the risk of fire. Another benefit is that LEDs are mercury-free and don’t contain any lead or arsenic. You might also consider upgrading if you experience frequent power outages.
As you can see, there are lots of reasons to upgrade your Wall Washer Light to LED. While it’s true that you’ll have to spend a little more on LEDs upfront, they last much longer than other types of lighting and end up saving you money in maintenance costs and energy usage over time.
Before You Make The Switch
If you’ve been using a regular porch light to make sure that your sidewalk is well lit, switching over to a Wall Washer Light can be the best thing you do. If your nightlight just doesn’t cut it anymore, it’s time for an upgrade. You might be ready for one if your current setup includes only two lights (one on either side of the house), or if one light on the front lawn is enough to illuminate everything.
Of course, before you even consider replacing your Wall Washer Light, you’ll want to make sure that it’s working properly. Check to see if your current fixture is generating too much heat, or if it’s creating glare for drivers or for people who are trying to walk up to your door.
Make Sure To Measure
Measure the dimensions of your Wall Washer Light from top to bottom, and from side to side. You must measure the size properly as an incorrect measurement will lead to a product not fitting. It is also important that you measure for any obstructions on the inside or outside of the wall where your light will be installed. These could include switches, plugs, outlets, or vents for example.
Additionally, you will need to measure where you would like your new Wall Washer Light to hang. Measure horizontally and vertically so that you can find out if there are any studs, pipes, or wiring on either side of where you want your product installed. This will help prevent drilling mistakes.
How To Wire The Connections
- The first thing you will need to do is remove the light housing from the existing fixture. Use a screwdriver to loosen the clips on the side that connect it to the electrical box.
- Once removed, feed the cables from your new kit through the old light housing and secure it with a wire nut or electrical tape.
Test The Light Fixture First
You should test the light fixture before buying a new one, to make sure it’s broken. Start by flipping the circuit breaker off and on, which will reset the power without turning off anything else. Next, check if any breakers have tripped or if you have a ground fault on your wiring panel. Then, go out and start the car for about 20 seconds, then turn it off and wait for about five minutes.
